08-09-2021, 04:07 PM
Type desk: Chimp 300.G2
Software version: V2.0.5
Connected USB-device: None
Networked devices: None
Description: When changing the Default-values of a RGBW-Module in a Multi-fixture to 0 (Red/Green/Blue/White) the first channel is not changed (in this case RED)
Steps to reproduce: Patch an iM2515 or IFX640 and go to the Module-editor, in the editor select all the default values from the RGBW-module (they are on 255) and change them to 0.
The first channel stays on 255 and is not editable.
Expected behaviour: All the RGBW-Default values should change to the value given.
Observed behaviour: Only the first channel is not changed or editable in the RGBW-Module, this does not only relate to the Default
Values but also on the Highlight / DMX-max etc.
Noticed that this error is also in the 4 Channel Helix (the 6 Channel version works)
Software version: V2.0.5
Connected USB-device: None
Networked devices: None
Description: When changing the Default-values of a RGBW-Module in a Multi-fixture to 0 (Red/Green/Blue/White) the first channel is not changed (in this case RED)
Steps to reproduce: Patch an iM2515 or IFX640 and go to the Module-editor, in the editor select all the default values from the RGBW-module (they are on 255) and change them to 0.
The first channel stays on 255 and is not editable.
Expected behaviour: All the RGBW-Default values should change to the value given.
Observed behaviour: Only the first channel is not changed or editable in the RGBW-Module, this does not only relate to the Default
Values but also on the Highlight / DMX-max etc.
Noticed that this error is also in the 4 Channel Helix (the 6 Channel version works)