22-11-2021, 10:45 PM
(This post was last modified: 23-11-2021, 11:53 AM by denishessberger.)
I selected two RGBW PAR fixtures and set their RGBW values to the color RED.
Then I selected two other RGBW PAR fxitures and set their RGBW values to BLUE.
I recorded the above mentioned programmer content to an empty preset and named it RED PRESET.
As I mistakenly also recorded the two blue fixtures into that preset, I wanted to remove them from the preset.
So, with a cleared programmer I loaded the preset (LOAD + Preset), selected the two blue fixtures and pressed REC -> REMOVE -> PRESET.
I expected, that this would remove the values in the programmer from the preset, but instead it deleted the complete preset.
As I tried to store a new preset on the place where the deleted one was, the suggested name reflected the old name RED PRESET. So it seems, there is also something left in the background...
Am I wrong, that you should be able to remove specific content from a preset as you are for a cue?
Best regards,
Edi
Then I selected two other RGBW PAR fxitures and set their RGBW values to BLUE.
I recorded the above mentioned programmer content to an empty preset and named it RED PRESET.
As I mistakenly also recorded the two blue fixtures into that preset, I wanted to remove them from the preset.
So, with a cleared programmer I loaded the preset (LOAD + Preset), selected the two blue fixtures and pressed REC -> REMOVE -> PRESET.
I expected, that this would remove the values in the programmer from the preset, but instead it deleted the complete preset.
As I tried to store a new preset on the place where the deleted one was, the suggested name reflected the old name RED PRESET. So it seems, there is also something left in the background...
Am I wrong, that you should be able to remove specific content from a preset as you are for a cue?
Best regards,
Edi