This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Mirror function for FAN CENTER
#1
When you have e.g. 8 Moving Heads in a line, the FAN CENTER function works perfect
for spreading the light over the stage widht by fanning the PAN from the middle to the outsides,
because PAN values of leftsided moving heads are decreased while PAN values of rightsided moving heads are increased.

But there is no possibility to spread the light from the back of the stage to the front of the stage by fanning the TILT values
where the centered moving heads remain in the back an the further away the moving heads are from the middle position on the truss,
the further the light should shine to the front of the stage. If you try that with the FAN CENTER function, the left sided moving heads
decrease their TILT to shine further to the back, while the right sided moving heads increase their TILT values to shine further to the front.

I think of an additional FAN CENTER MIRROR function, where the values are still fanned from the center position, but both fixture selection parts 
(leftside / rightside) have the same sign (+ / -) for the change of the parameter value (PAN / TILT / FOCUS, etc.).
And this method for fanning values would also be very useful for fanning individual parameter timing (think of a delayed fade in of the fixtures from the center to the sides).
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)