Highlite Forum

Running Chimp 100 V1.12 beta with one touchscreen connected and two dmx outputs in use.

When i try to fan my P/T position it only work when there are values in the programmer. Most of the time i make a base position (straight forward) and from there on i make my other preset positions. But when i want to use the fanning option nothing happens.

The name from the preset will appear in the programmer and then i cannot use the fanning options.
But when there are just values in the programmer the fanning works just fine.

This is also happening on the OnPc version that i use at home.

Hope this will be checked 

Best Regards,
Tom

Hi Tom,

thanks for you report! We already know about this issue and it will be fixed in the next release. As a work around: Load the base preset by pressing [Infinity] while selecting the Preset (this will load the preset without a reference to it), or touch the encoders slightly so that the values are shown again in the programmer, then Fanning will work again.

Denis

This will be fixed in the "Multicell" Release, Version 2.0