31-01-2021, 08:54 PM
(This post was last modified: 23-03-2021, 10:12 PM by denishessberger.)
Running Chimp 100 V1.12 beta with one touchscreen connected and two dmx outputs in use.
When i try to fan my P/T position it only work when there are values in the programmer. Most of the time i make a base position (straight forward) and from there on i make my other preset positions. But when i want to use the fanning option nothing happens.
The name from the preset will appear in the programmer and then i cannot use the fanning options.
But when there are just values in the programmer the fanning works just fine.
This is also happening on the OnPc version that i use at home.
Hope this will be checkedĀ
Best Regards,
Tom
When i try to fan my P/T position it only work when there are values in the programmer. Most of the time i make a base position (straight forward) and from there on i make my other preset positions. But when i want to use the fanning option nothing happens.
The name from the preset will appear in the programmer and then i cannot use the fanning options.
But when there are just values in the programmer the fanning works just fine.
This is also happening on the OnPc version that i use at home.
Hope this will be checkedĀ
Best Regards,
Tom