+- Highlite Forum (https://forum.highlite.com)
+-- Forum: Infinity Chimp (https://forum.highlite.com/forumdisplay.php?fid=46)
+--- Forum: Chimp 1.12 Open Beta (https://forum.highlite.com/forumdisplay.php?fid=57)
+--- Thread: [Fixed in 2.0] Chimp 100, V1.12, fanning Values (/showthread.php?tid=1017)
[Fixed in 2.0] Chimp 100, V1.12, fanning Values - Tom TK - 31-01-2021
Running Chimp 100 V1.12 beta with one touchscreen connected and two dmx outputs in use.
When i try to fan my P/T position it only work when there are values in the programmer. Most of the time i make a base position (straight forward) and from there on i make my other preset positions. But when i want to use the fanning option nothing happens.
The name from the preset will appear in the programmer and then i cannot use the fanning options.
But when there are just values in the programmer the fanning works just fine.
This is also happening on the OnPc version that i use at home.
Hope this will be checked
Best Regards,
Tom
RE: Chimp 100, V1.12, fanning Values - denishessberger - 01-02-2021
Hi Tom,
thanks for you report! We already know about this issue and it will be fixed in the next release. As a work around: Load the base preset by pressing [Infinity] while selecting the Preset (this will load the preset without a reference to it), or touch the encoders slightly so that the values are shown again in the programmer, then Fanning will work again.
Denis
RE: [Fixed in 2.0] Chimp 100, V1.12, fanning Values - denishessberger - 23-03-2021
This will be fixed in the "Multicell" Release, Version 2.0