08-04-2019, 08:35 AM
(This post was last modified: 07-08-2020, 05:42 PM by denishessberger.)
Record the color "RED" for a RGB PAR fixture to a cuelist and set the cuelist to "Release at End".
Link the cuelist to an executor button.
As long as the cue has a FadeIn Time (eg. 1 second) the behaviour is correct when the exceutor button is pressed. The cue is fired and the cuelist is released again.
When the cues FadeIn Time is set to zero, the cuelist is no longer released after the cue has been fired.
It is the same behaviour when more than one cue is recorded into the list. When FadeIn time is set to zero on the last cue, the cuelist is not released after the last cue has been fired,
But this is different when the last cue is automatically triggered (Follow or Wait trigger). The cuelist is then never released at end independet from the FadeIn time. This did work in V1.08.
Link the cuelist to an executor button.
As long as the cue has a FadeIn Time (eg. 1 second) the behaviour is correct when the exceutor button is pressed. The cue is fired and the cuelist is released again.
When the cues FadeIn Time is set to zero, the cuelist is no longer released after the cue has been fired.
It is the same behaviour when more than one cue is recorded into the list. When FadeIn time is set to zero on the last cue, the cuelist is not released after the last cue has been fired,
But this is different when the last cue is automatically triggered (Follow or Wait trigger). The cuelist is then never released at end independet from the FadeIn time. This did work in V1.08.
