05-02-2019, 12:41 AM
(This post was last modified: 07-02-2019, 12:22 PM by Edi_28.
Edit Reason: Update
)
When you have a Cuelist 1 with several Cues and hit "Load Cuelist 1 Enter" the "Select Cue" window opens. There it should be possible so scroll through the Cues with Wheel 1.
This does not work.
Tested on version 1.08
Update:
It seem's that the "Scroll table" function in general only moves the vertical scroll bar when the list is longer than the window is able to show. I've also recognized this when editing a fixture wher you set a lot of ranges for one channel. It would be great if the scrolling with the wheel would move the selected line which can be edited when the wheel is pressed (= SET / ENTER)
This does not work.
Tested on version 1.08
Update:
It seem's that the "Scroll table" function in general only moves the vertical scroll bar when the list is longer than the window is able to show. I've also recognized this when editing a fixture wher you set a lot of ranges for one channel. It would be great if the scrolling with the wheel would move the selected line which can be edited when the wheel is pressed (= SET / ENTER)