V2.1 Loading an existing cue, puts previously unrecorded parameters to the programmer

[Edi_28]

On the last show I did, I had to change an existing cue, because I had to modify the position of some moving heads an recognized an unwanted behaviour.

When I loaded the cue to the programm with LOAD + selecting the cue, I saw that also the Pan/Tilt Speed (PT Speed) parameter was highlited in RED in the programmer. This also happens to other parameters (e.g. the shutter parameter when you are in the dimmer attribute section). It seems, that always the 3rd parameter of an attribute page is also put to the programmer as a changed value.

[Angelo]

This is strange, never saw this error.

Can you make a short video of this problem and send it to us?

( Email it to: Chimp@Highlite.com via Wetransfer)




Edi_28On the last show I did, I had to change an existing cue, because I had to modify the position of some moving heads an recognized an unwanted behaviour.

When I loaded the cue to the programm with LOAD + selecting the cue, I saw that also the Pan/Tilt Speed (PT Speed) parameter was highlited in RED in the programmer. This also happens to other parameters (e.g. the shutter parameter when you are in the dimmer attribute section). It seems, that always the 3rd parameter of an attribute page is also put to the programmer as a changed value.