17-05-2025, 04:20 PM
Using FW 2.1.3: I'm using the master fader as speed fader to be able to change the fade time between the cues in my cuelists. Perfect. But: when I select a new cuelist, the speed is set to 100%, no matter what the previously used speed was...
Note: I'm using the cuelist button as "select playback".
So scenario is this:
- two cuelists available, both with the same fade times (100ms) for the cues
- master fader = speed fader
- cuelist button = select playback
- cuelist fader = infade
- select first cuelist
- use master fader to set speed to 20%
- use master go button to show the cues
- now switch to the other cuelist
- jus ta look at the master playback info shows the problem: the speed is set to 100%, although I never touched the master fader (which should still be at 20% in my opinion)
Note: I'm using the cuelist button as "select playback".
So scenario is this:
- two cuelists available, both with the same fade times (100ms) for the cues
- master fader = speed fader
- cuelist button = select playback
- cuelist fader = infade
- select first cuelist
- use master fader to set speed to 20%
- use master go button to show the cues
- now switch to the other cuelist
- jus ta look at the master playback info shows the problem: the speed is set to 100%, although I never touched the master fader (which should still be at 20% in my opinion)