02-02-2022, 01:21 PM
Type of the Desk: LAMPY 20 2U
Software Version: 1.03
No external Display
Connected USB Devices: 3
Networked Devices: Router and NET 2/3 Pocket
Short Description:
1. When adding freshly patched fixtures to one of the magic sheets, when klicking on cancel after selecting a arrangement option, all other/earlier added fixtures will be deleted from the sheet.
2. It's not possible to set the PAN/TILT area in degrees with the encoders in the fixture editor when creating a user fixture (as described in the GB version of the manual, page 87).
Steps to reproduce:
1. Add some fixtures to one of the sheets. Then patch new fixtures, select an arrangement, select the sheet with the other fixtures and when the freshly patched fixtures are shown on the sheet ready to be arranged klick on cancel instead of confirm.
2. Create a new fixture and in the "General Settings" tab of the fixture try to set a PAN/TILT range with the encoders.
Expected Behaviour:
I expect the fixtures on the sheet would not be deleted as it's time consuming if I have to add the fixtures again, especially in larger/bigger setups. Furthermore I wish to set the ranges for PAN/TILT so I can program my moving lights more precisely.
Software Version: 1.03
No external Display
Connected USB Devices: 3
Networked Devices: Router and NET 2/3 Pocket
Short Description:
1. When adding freshly patched fixtures to one of the magic sheets, when klicking on cancel after selecting a arrangement option, all other/earlier added fixtures will be deleted from the sheet.
2. It's not possible to set the PAN/TILT area in degrees with the encoders in the fixture editor when creating a user fixture (as described in the GB version of the manual, page 87).
Steps to reproduce:
1. Add some fixtures to one of the sheets. Then patch new fixtures, select an arrangement, select the sheet with the other fixtures and when the freshly patched fixtures are shown on the sheet ready to be arranged klick on cancel instead of confirm.
2. Create a new fixture and in the "General Settings" tab of the fixture try to set a PAN/TILT range with the encoders.
Expected Behaviour:
I expect the fixtures on the sheet would not be deleted as it's time consuming if I have to add the fixtures again, especially in larger/bigger setups. Furthermore I wish to set the ranges for PAN/TILT so I can program my moving lights more precisely.