Show Name of Preset, Cue, etc. loaded to programmer
#1
When loading a preset, cue, etc. to the programmer, it would be nice if the name (at least its number) could be shown in the programmer title bar or somewhere else suiteable. Additionally an asterisk behind the name would also be very nice in case any value has changed compared to the original version.

Sometimes when I modify existing cues in big shows it's hard to exactly remember to which cue, preset and so on I have to merge my changes to not accidentially update an other one...
Reply

#2
Very good point. What I also don't like is that the programmer is always replaced. A merging function in combination with a store mode "programmer content for selected fixtures" (red values for current fixture selection) would be quite good at this point. Ultra would of course be a 2nd separate programmer especially for loaded cues, where you can make your changes and then update the original cue directly or save it in another cue.

Regards.
Reply

#3
First time poster. I really really really want this to happen.
Reply



Forum Jump:


Users browsing this thread:
2 Guest(s)