"End Kernel panic" error after reboot
#1
A reboot was performed after updating the firmware from 1.12 beta to 2.0.5 on Infinity Chimp 100, after which such an error began to appear. I believe that the update process was not completed to the end for some reason
What to do in such a situation?


Attached Files Thumbnail(s)
   
Reply

#2
mr mine said:
If you have updated the firmware on your Infinity Chimp 100 console and are experiencing errors or missing internal universes, here are a few steps you can try to resolve the issue:

Power cycle the console: Turn off the console, unplug it from the power source, wait for a few minutes, and then plug it back in and turn it on again.

Factory reset: Try performing a factory reset on the console. Please note that a factory reset will erase all settings and data on the device, so make sure to back up any important data before proceeding.

Contact technical support: If the above steps don't resolve the issue, it's best to reach out to the technical support team of the console manufacturer. They will have the most relevant knowledge and expertise to assist you with troubleshooting the specific issue you're facing.
Reply



Forum Jump:


Users browsing this thread:
1 Guest(s)