The programmer is not always loaded / update with the correct values.
Following example:
- Patch two dimmers
- Select the two dimmer fixtures, add Dimmer Wave Fx and record to fader 1
- Set fader 1 to 60%
- Select fixture 1 and press INFINITY + LOAD
- Current output for fixture 1 is loaded to programmer -> OK
- Now move fader 1 to 100%
- Also select fixture 2 an press INFINITY + LOAD again
- Current output for fixture 2 is loaded to programmer too, but current output for fixture 1 is not updated to new value -> NOT OK
- Even more worse is, that the fixture count in the FX is not updated to 2!!! -> ALSO NOT OK
The same problem exists when you press LOAD and select an attribute group on the touchscreen
LOAD+Effects does not update the selected fixtures when you have added a fixture to the selection after you have once called LOAD+Effects with an other fixture selection.
In my opinion, every INFINITY+LOAD or LOAD+AttributeGroup or LOAD+FIXTURE or LOAD+EFFECTS should update the programmer values for the selected fixtures.
Following example:
- Patch two dimmers
- Select the two dimmer fixtures, add Dimmer Wave Fx and record to fader 1
- Set fader 1 to 60%
- Select fixture 1 and press INFINITY + LOAD
- Current output for fixture 1 is loaded to programmer -> OK
- Now move fader 1 to 100%
- Also select fixture 2 an press INFINITY + LOAD again
- Current output for fixture 2 is loaded to programmer too, but current output for fixture 1 is not updated to new value -> NOT OK
- Even more worse is, that the fixture count in the FX is not updated to 2!!! -> ALSO NOT OK
The same problem exists when you press LOAD and select an attribute group on the touchscreen
LOAD+Effects does not update the selected fixtures when you have added a fixture to the selection after you have once called LOAD+Effects with an other fixture selection.
In my opinion, every INFINITY+LOAD or LOAD+AttributeGroup or LOAD+FIXTURE or LOAD+EFFECTS should update the programmer values for the selected fixtures.