Currently using version 2.0.6 on chimp 100 tour pack.
I had a cue in which a position, gobo, beam and also a tilt FX was stored. I wanted to remove the position information for that cue, so the tilt FX will be applied to whatever position the moving heads are currenlty pointing to.
So I loaded this cue to the programmer and held [OFF] + touching the attribute group for [Position]. But this not only cleared the position information from the programmer, it also cleared the FX, which must be a bug.

Version 2.0.6 on Chimp 100 Tourpack
When you press key [LINK] then any executor or fader key and you choose then the tab "Groups" from the dialog, the console kinda restarts (like reboot GUI).

When loading a preset, cue, etc. to the programmer, it would be nice if the name (at least its number) could be shown in the programmer title bar or somewhere else suiteable. Additionally an asterisk behind the name would also be very nice in case any value has changed compared to the original version.

Sometimes when I modify existing cues in big shows it's hard to exactly remember to which cue, preset and so on I have to merge my changes to not accidentially update an other one...

Found in version 2.0.6
When you have added a cue list to the magic sheet and you move this cue list to another number in the cue list windows, you have then an empty cue list referenced by the magic sheet, as this still points to the old storage location. It also shows up in the usage window.
In my opinion moving a cue list to another cue list number should also update the referenced icon in the magic sheet.

It would be great to have the possibility to change the name for the master faders. Having 3 FX size masters always requires marking tape to know WHAT is controlled by the master…
Same applies to fade masters, and so on…
Interestingly it is already possible to use the naming function on master faders, but the entered name is neither shown nor saved.

Hi!
Is there any chance to connect the Chimp onPC Software with some kind of visualisation software without the need of additional hardware? That would be extremely handy for pre programming on the road or at home where I don't have the possibility to set up a console.

Hi chimps, 
I couldn't found those fixture in the library, so after this question put on the Facebook page , I tryed to make my own fixture,.  But It doesn't work at the way it schould be.. (I guess) When I created it I see 5 Fixtures (4x dimmer, 1x Shutter) why is my shutter not hided and when I take a n other multiple fixture for tamplate, I can't save it, the  "dimmer" stays red. 
So my question:
How can I create a multi fixture (4x dim, 1x shutter) and see only 4 fixture in my show?  (without the shutter as a separate fixture)
or
How can I update the Library, there's no link at the Highlite site and you have  a acount at the Altabase site?

With all regards,

Hans

Hi! 
Is there a easy way to get these modes for lampy. I attached cameos own info on how the channels are configured.

Attached Files

  CLPIXBAR600PRO_Cameo_DMX_Control_Table (1).pdf (Size: 78,18 KB / Downloads: 4)

I'm going to have an event next on sunday with 16 P9 from JB. Is the fixture already in the libary as it is pretty new?
JB supplies a GDTF file on the website -> https://www.jb-lighting.de/P9Spot

BR 
Moritz

Hi there,
a direct goto cue action inside the cuelist view without the need to select the cuelist and use the goto command would be nice