[Fixed in 2.0] Chimp 100, V1.12, fanning Values

[Tom TK]

Running Chimp 100 V1.12 beta with one touchscreen connected and two dmx outputs in use.

When i try to fan my P/T position it only work when there are values in the programmer. Most of the time i make a base position (straight forward) and from there on i make my other preset positions. But when i want to use the fanning option nothing happens.

The name from the preset will appear in the programmer and then i cannot use the fanning options.
But when there are just values in the programmer the fanning works just fine.

This is also happening on the OnPc version that i use at home.

Hope this will be checked 

Best Regards,
Tom

[denishessberger]

Hi Tom,

thanks for you report! We already know about this issue and it will be fixed in the next release. As a work around: Load the base preset by pressing [Infinity] while selecting the Preset (this will load the preset without a reference to it), or touch the encoders slightly so that the values are shown again in the programmer, then Fanning will work again.

Denis

[denishessberger]

This will be fixed in the "Multicell" Release, Version 2.0